January 22, 2010The other morning while driving I notice that my left/right turn signal not working. The funny thing is the hazard light will flash if turned on, but the turn signal nothing. I checked the manual to see if there is a fuse for the turn signal but no luck, i only see a fuse for the flasher. Any idea, i would hate to have an electrical problem.
Forums : Appearance : Turn Signal wont work (195 Views)
January 22, 2010check for socket grounds.
if you have a jumper wire that you can climp to a known ground. then attach it to the light socket on one side and try the turn siganl. do that to both sides to see if they are still grounded.
January 22, 2010I`m also wondering if the turn signal cam could have gone bad. I think the hazard lights flash off a separate mechanism? Not something that would usually go wrong though unless it was messed with.
The turn signals though do have a fuse, but if your hazards are working then that fuse should be ok.
January 23, 2010Don`t know, this is why I`m asking - Do Expy`s have a single flasher unit or two?
January 23, 2010TWO,there is also a mini fuse box on the left side of the engine
compartment just to the rear of the power distribution box. There is
turn signal fuse in there also.
January 23, 2010There is Two fuse unit in the engine compartment. I only checked one, i will take a look in the morning. Is it only me, that none of my fuse box is label to tell what fuse is what. I have to go digging in the manual.
January 24, 2010nope, not just you. mine aren`t labeled either
January 25, 2010I`m still trying to tackle this turn signal, honestly i don`t have enough time.I went to pep boys today and i was told that my car has turn signal relay they had one instock but its bigger than the ones in my car and of course its an aftermaket part. Beside in my car i hace about12 of those relay and nothing is label saying where it belong. Does anyone have an idea.
January 25, 2010Your owners manual has pictures that show what relay controls what.
January 25, 2010You might wanna read this thread:
Chris knows a lot about electrical stuff - Put a link to this thread there and ask him your question. He may be able to point you in the right direction.